Create Door Hangers

Here’s how to quickly create door hangers, 2 to a page, using iMenuPro:

1. Start with a new blank menu using File > New Menu

2. Use File > Page Setup and choose Paper Size > Custom and enter a custom width of 4.25” and a custom height of 11” (you can vary these numbers depending on the hanger size you want).

3. Also on Page Setup change the Top Margin to 2” or more (enough room for a standard 1.5” hole punch).

4. To view approximately where the hole will be punched, use the Grid command, View > Grid > Door Hanger > Show on Menu

5. Next, create your door hanger menu or flyer just like would any other menu.

6. Rename and save your door hanger using File > Rename Menu and File > Save Menu.

7. When ready to print to PDF, create 2 door hangers per page using Tools > Table Tent > 4-UP. For double-sided hangers make page 2 the back - that way your paper size, margins, and any style tweaks are already set. See our section on 2-sided printing HERE

8. Once printed, punch the top center hole using a 1.5” craft hole puncher available at most craft stores for around $10.

9. Lastly, cut the notch using a pair of scissors, cutting from the top (or side) and into the hole area at a slight angle.